Measure
138
Note:
12.2
Set Measurement Types
To add a measurement in
Advanced
mode:
1.
Touch the
Type
option in the measure menu, or touch the + in the measurement parameters and statistics display
area.
–
The
Measure Select
window will be displayed. See figure
Figure 12.5
Measure Select
2.
Set the Source of the current setting.
3.
Select the tab that include the desired measurement.
–
The corresponding parameters of the selected tab will be displayed below the tab area.
4.
Use the touchscreen to select the desired measurement.
A source must be selected before selecting a measurement. For delay measurements the channel corresponding to Source
A is specified first, and then the channel corresponding to Source B. Finally, the measurement parameter is selected.
5.
To remove single measurements, touch the
-
in the upper right corner of the measurement.
6.
To remove all measurements simultaneously touch the
Clear
option in the measure menu.
Содержание 2560B Series
