Mode 1
: “ON/OFF” The relay is triggered
and deactivates alternatively with each
signal received.
Mode 2
: “Pulse” The relay is triggered
during 1 second when receiving a signal.
The operating modes can be configured
by means of the jumper JP1 (see figure)
JP1
OFF
(jumper disconnected):
Pulse
mode
JP1
ON
(jumper connected):
ON/OFF
mode
Use the RF code selector to select the
code that will activate the Enabler. The
code selector allows up to 10 positions.
See in the table below the code assigned
to each position:
Selector
RF code
0
48
1
49
2
50
3
51
4
52
5
53
6
54
7
55
8
56
9
57
Table 1
To use the Enabler:
1.
The device must be installed in
accordance with the installation
instructions (see section 4).
2.
Program the RF code in the BJ
System’s remote controller based on
the position of the selector and the
corresponding value in Table 1. See
the controller’s user guide to learn
how to program the RF codes.
3.
The Enabler will activate/deactivate
the load depending on the mode
selected (see section 5) when the
programmed button in the controller
is pressed.
4.
If external switches have been
installed, the load can be turned on
and off using these elements.
Enabling multiple receivers at once:
To enable multiple receivers plugged in
different locations and that these are
activated at once, simply adjust the "RF
code selector" in the same position on all
receivers.
Activation of different receivers:
To enable multiple receivers, so that
each one is activated with a different
action in the controller, simply adjust the
"RF code selector" in a different position
on each receiver.
The Enabler can be cleaned using a
damp soft cloth. Always carry this
operation out with the Enabler
disconnected.
In the event of a fault in the Enabler, do
not handle it and contact your
distributor.
Waste electrical products should
not be disposed of with household
waste!
Dispose of the waste product
via a collection point for
electronic scrap or via your
specialist dealer. Any
unauthorized tampering with,
or modifications to the product
will annul this warranty.
Within the statutory warranty period we
undertake to rectify free of charge by
repair or replacement any product
defects arising from material or
production faults.
Any unauthorized tampering with, or
modifications to the product will annul
this warranty.
This product complies with the essential
requirements of the Directives
2004/108/EC and
2006/95/CEE
.
The Declaration of Conformity can be
downloaded from the product’s webpage
If, despite of correct handling, faults or
malfunctions occur or if the product was
damaged, please contact us at the
following address:
BJ Adaptaciones
C/ Mare de Déu del Coll, 70, Bajos
08023 Barcelona
España
Phone:+34 93 285 04 37
Fax: + 34 93 553 56 34
Maintenance
Disposal
Warranty
Conformity
Customer Service
6. Using the Enabler
IMPORTANT
:
To change the code in the
selector, disconnect the Enabler
from the power supply, wait five
seconds and reconnect the
circuit.
7. General information
Dealer information:
