VIDEO:
www.bixpy.com/po-assembly
Bixpy Hobie
®
Pro Angler
™
Adapter
5
Attach your Bixpy adapter to your Bixpy Jet
1. Align connector pins
2. Pull nose latch forward to allow metal toe to sit flush
3. Attach power cord (turn 180° and “click” closed)
4. Close rear spring latch
3
2
4
1
6
Adjust your tilt and height
1. Adjust your tilt using the five holes provided
2. Use the pipe clamps to adjust the height of your motor.
3. If you set your motor too low, it will not lift out of water
when you pull your motor lift cord. Adjust the height
with your kayak loaded.
The top of your motor should be about 3” below water.
11
2
4
Assemble your adapter
1. Use the two knurled bolts to assemble the vertical and
horizontal assemblies together
2. Since you will use your Hobie
3. Take special care to make sure you do not damage your
power cord when drilling your pipe. DO NOT DRILL THROUGH!!!
®
rudder for steering, you
can lock your vertical pipe and prevent turning. Use
the provided threaded screws to lock down your vertical pipe.
You will need to drill a 1/8” hole into the aluminum pipe.
See step 6 for height adjustment BEFORE drilling your holes.
2
1
