Bittel UNO Media 68 Series, Быстрый старт, Страница: 4 / 6

Programming the Speed Dial Keys
To program the speed dial keys, follow these steps
below.
NOTE: Make sure that the phone is in an “on-hook”
state (not active, with handset in the cradle, and
speakerphone not engaged).
1. Press the HOLD key.
2. Enter the phone number or dial string to be
saved to memory.
4. Press the HOLD key again.
2. Press the speed dial key to be programmed.
This completes the programming procedure for
this key. To program additional speed dial keys,
repeate the procedure as above.
Programming the Flash Duration
CAUTION: Do not make changes to Flash duration
unless you are certain that this is required. Only
change Flash duration if required for proper PBX
interaction with UNO.
Standard Flash duration is 600 ms.
1. Press the HOLD key.
2. Depending on the desired Flash duration, press
the corresponding key as referenced here:
1 – 100 ms 7 – 700 ms
2 – 200 ms 8 – 800 ms
3 – 300 ms 9 – 900 ms
4 – 400 ms 0 – 1000 ms
5 – 500 ms * – 1100 ms
6 – 600 ms # – 1200 ms
(In other words, pressing the “3” key will
program the Flash for a 300 ms duration, etc.)
3. Press the HOLD key.
4. Press the FLASH key.
Flash is now programmed to the duration selected.
ALARM CLOCK/RADIO FUNCTIONS
Bittel UNO Media features an easy-to-use alarm
clock radio, with an FM tuner and line-in audio
interface to enable the enjoyment of music on
personal portable electronics, such as iPod
®
s and
other similar mp3 players, cell phones, or other
devices. The information in this section will guide
you through the use and setup of some of the
audio features of your Bittel UNO Media.
Setting the Clock
If you are plugging your UNO in for the first time,
the clock may need to be set.
To set the clock:
1. With the audio off, press the VOLUME - key for
one second and release. The hour digit(s)
will begin to flash.
2. Press the or - keys to adjust the hour.
3. Press the VOLUME - key again. The minutes
digit(s) will begin to flash.
4. Press the or - keys to adjust
the minutes.
5. Press the VOLUME - key again to end the
operation.
Press the key to toggle 12-hour or
24-hour time format.
NOTE: You may also set the time on your UNO
using an optional time-set remote control. The use
of this device is covered later in this guide.
Setting the Alarm
1. Press the ALARM SET key. The hour digit(s) will
begin to flash.
2. Press or - to adjust the hour.
3. Press the ALARM SET key. The minutes digit(s)
will begin to flash.
4. Press or - to adjust the minutes.
5. Press the ALARM SET key again to end the
operation. The alarm is now set.