www.bitrek.eu
+380 44 507 02 07
To establish the connection you need:
7.1.1.
Remove the tracker’s 4 screws on the bottom cover, and then remove the
top cover.
7.1.2.
Connect cable for configuration to XP7 jack on the top chip.
Red
cable
must be connected to pins 1 both on tracker and programmer (picture 7.5).
7.1.3.
Connect USB-A – USB-B cable with the narrow connector to
programmer, and with wide connector to any free USB-port of your PC.
7.1.4.
Apply 12-24V power on tracker’s appropriate contacts (picture 6.1.).
BI 810 TREK
BI 820 TREK
BI 820 TREK (OBD)
BI 310 CICADA
X
P
7
X
P
8
1
2
3
4
5
6
BI 868 TREK
3
2
1
Picture 7.5. Tracker to programmer connection
After tracker connection to PC is successful, your operating system will
automatically install driver for programmer. If the automatic driver installation
has
not
occurred,
download
it
from
the
link
http://www.ftdichip.com/Drivers/VCP.htm
or from
BITREK
TM
corporate websites
www.bitrek.eu
or
www.bitrek.com.ua
.
7.2.
Remote tracker configuration
For remote configuration, you need to have a power source 12-24V and a GSM
modem with an activated SIM-card with available SMS service inserted in.
GSM-modems supported models
*
:
BITREK GSM-modem
Cinterion MC35i
*
GSM-modems, which were tested with
BITREK CONFIGURATOR
.
BITREK CONFIGURATOR
can work with any GSM-modem, connected to the COM-port of PC.
Activated SIM-card with available SMS and GPRS services must
be inserted in tracker. On SIM-card PIN-code verification needs
to be removed and the phone book needs to be empty. If you
are going to use voice communication, voice services also needs
to be activated on the SIM-card.
