25
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
Setting the device to work with tires pressure sensors
via RS-232
“BI 530P TREK” tracking device has the ability to work with tires
pressure sensors (CUB TPMS) via RS-232 interface. In total, up to 23
sensors can be connected simultaneously. The tracker can collect and
transmit information about the current value of pressure and air
temperature for each of the sensors to the server. A list of all available
I/O-elements for working with pressure sensors is provided in
To enable work with pressure sensors it is necessary to set the
appropriate mode of operation for RS-232. To do this, send the
command:
setparam 5007 5;
Receiver connector pinout is discribed at Figure.8.
Figure 8. CUB receiver connector pinout
No.
Contact
name
Signal type
Description
1
TX
Input/output
Signal «TX» RS-232
2
RX
Input/output
Signal «RX» RS-232
3
N\C
-
Not connected
4
GND
Power
Common wire (ground)
