10
The brush and drive belt should both regularly be checked for
wear or damage. You should also keep the brush and brush ends
free of string, hair, and carpet fibers as these can become
entangled in the brush and reduce its cleaning effectiveness.
NOTE: The brush can most often be cleaned
without removal from the vacuum. If there is an
excessive amount of hair and debris, however, it
is best to remove the brush.
Unplug the vacuum. Tip unit over, face down, on a flat surface.
Remove all 3 screws from the bottom of the Powerfoot.
Grip both the top cover and base while turning unit back
over. Lift off top cover.
Check Belt. If it is broken or damaged, Brush Roll needs
to be removed before replacing a new belt.
To remove the Brush Roll, pull the right side of the Brush
Roll toward the front of the Powerfoot as you lift slowly.
Clean off brush roll as necessary.
Place existing or new Belt over Brush Roll Pulley and the
Motor Shaft. Insert the End Cap Pin on the left of the
Brush Roll into the slot on the Powerfoot and slide the
End Cap Pin on the right end of the Brush Roll in to the
slot in the Powerfoot and lower until it clicks into place.
Make sure the Furniture Protection Guard is still intact.
Align the 3 tabs on the top cover with the 3 slots in the
Powerfoot. Press into place, making sure the Furniture
Protection Guard is on the outside.
Turn vacuum cleaner back face down.
Replace the 3 screws.
Note: It may be easier to begin with the center screw.
Replacement Belt: BISSELL
®
Replacement Belt
Style 6 (#32053, package of 2).
Checking the Rotating Brush and Drive Belt
6.
7.
8.
1.
2.
3.
4.
Cleaning the Brush/Replacing the Drive Belt
5.
9.
10.
11.
1
2
5
7
