First attach left side (short Tab) catching Tab over Floor Nozzle edge.
Gently bend long Tab (right side) outward to easily snap over
edge of clear nozzle on left.
Set up machine following instructions in the
Features
section on pages 6-10. Be sure to thoroughly rinse out any
remaining BISSELL Advanced Deep Cleaning Formula from
the SmartMix Bottle to prevent slippery linoleum, vinyl, and
tile floors.
Use BISSELL Floor Cleansing Formula in the
SmartMix Bottle.
Check ReadyTools Dial - it should be set on
Floor Cleaning
.
Choose the SmartMix setting to match the cleaning job.
Plug into a proper outlet and turn Power Switch ON. The
SmartTemp Ready Light illuminates and the PowerWash
ProHeat is ready to clean.
Slowly move the machine Nozzle with Bare Floor Tool forward
and back over soiled surface one time while pressing the trigger.
Caution: Do not over wet.
Repeat the motion without pressing the trigger using the Bare
Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
Allow about 30 minutes for the floor to dry completely.
When the cleaning job is complete refer to the
Maintenance
section on pages 15-16 for machine clean
up and storage instructions.
To remove Bare Floor Tool, gently bend long Tab (right side)
outward and pull tool down away, from the Floor Nozzle. Rinse
thoroughly, dry and store
Turn Power Switch OFF.
Unplug Power Cord from the outlet and coil around Power
Cord Quick Release.
15
6.
Machine Preparation
1.
2.
3.
4.
Attach the Bare Floor Tool Continued
5.
1.
2.
3.
4.
5.
6.
Bare Floor Cleaning Technique
Routine Maintenance
1.
2.
Tip:
SmartMix Bottle
may be stored
with cleaning
solution for your
next cleaning job.
Make sure dial
is turned to the
Water Only setting
when storing.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
