T
roubleshooting
17
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
DirtLifter PowerBrush does not turn.
Possible Cause
Remedies
1. The Brush Belt or Pump Belt
1. Turn the machine
OFF (O)
and unplug
is off or broken.
from the outlet. To check if the brush
belt or pump belt has broken, you
will need a flat head screwdriver.
Insert the blade end into the lower
slot of the belt access door to release
the lower snap. If necessary, insert
the blade end into the upper slot to
release the upper snap. Examine the
belt for breakage. If broken, please
refer to Replacement Parts on page 19
before calling Consumer Services.
Complete installation instructions
will accompany the replacement belt.
Cleaner not picking up solution.
Possible Causes
Remedies
1. Ready tools dial may be on the
1. Set ready tools dial to either or
wrong setting for the cleaning job.
tools or pretreat floor cleaning.
2. Nozzle window may not be
2. Press down firmly on the black
properly attached.
oval gasket at the top window to
make sure the two tabs on the
back of the nozzle window are
snapped into the mating slots in
the main housing.
3.
2-in-1 water tank lid is not properly installed.
3.
Re-install lid; refer to page 9.
4.
2-in-1 water tank is not properly seated.
4.
2-in-1 water tank must be firmly
seated to function; remove and
reseat 2-in-1 water tank.
5.
Poor tool position.
5.
Adjust angle; apply more
(Hand held attachments only).
downward pressure.
6.
2-in-1 water tank has picked up
6.
Empty 2-in-1 water tank, refer to
maximum dirty water.
page 11.
Other Maintenance or Service not included above should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call 1-800-237-7691
Please do not return this product to the store
ug120-4080_7350_908.indd 17
10/14/08 1:28:09 PM
