www.BISSELL.ca
8
Mainte nan ce & Care
Cleaning the dirt container
1.
Release dirt tank as above, then twist
the top right to separate.
2.
Remove filter by pulling up on the fabric
tab, then pull out the cyclone system.
3.
Rinse and dry dirt container with a paper
towel.
4.
To reassemble, line cyclone system up with
dirt container using the semi circular and
square tabs then slide in. Place filter on top
with fabric tab on the upper face, place lid
last and twist left.
Cleaning the filter and cyclone
1.
Release tank and remove lid as above,
then remove Pre‑motor Filter, clean with mild
detergent and rinse.
2.
Reinsert inside Dirt Container, once
completely dried.
3.
Remove cyclone system from dirt container
as above.
4.
The cyclone system can be broken down
into three parts for easy cleaning. All pieces
come apart with a simple twist. Rinse and dry
with a paper towel.
Replacing the Brush
1.
Turn power switch off, turn over and use a
coin or a flathead screwdriver to open the 2
locking screws on either side of the brush bar.
2.
Remove both brush plates to access
brush bar.
3.
Grasp the roller from the bottom, dislodge
by pulling, and then thread it through the belt.
4.
Replace roller and reverse the order to
reassemble.
1.
3.
4.
1.
2.
1.
3.
4.
3.
2.
4.
2.
WARNING
Do not operate cleaner with damp or wet fi lters or without
vacuum bags and all fi lters in place.
» To maintain suction and good performance, it is
recommended that you clean your filters every
4‑5 uses and clean your cyclone system every
other time you clean the filter.
Tip
