www.BISSELL.com
10
Cleaning Foot of Unit
1.
To clean the foot and bristles, push the release
button on the back of the pivot joint and pull the
foot to release it from the appliance.
2.
Wash bottom of foot and bristles with
cold water.
3.
Look for any clogging in the steam nozzle.
To clean, run water over steam nozzle.
NOTE: Make sure foot and bristles are dry
before attaching the foot to the appliance.
4.
To re-attach the foot to the appliance: place
the foot on the floor, push the appliance down
into the foot and then listen for the click that
sounds when properly attached.
Maintenance & Care
2.
Troubleshooting
WARNING
To reduce the risk of electric shock, turn power OFF and
disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
WARNING
To reduce the risk of electric shock, turn power OFF and
disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
Problem
Possible causes
Remedies
Vacuum
cleaner
has low
suction
Dirt Tank is full
Empty Dirt Tank
Dirt Tank is not installed properly
Position tank correctly and
move lock button to the right until
it is in the center of the unit
Foot is loose
Make sure foot is fully inserted into
body of unit
Filters need cleaning
Follow filter instructions on page 9
Filters need replacing
Visit www.BISSELL.com to order
replacement filters
Hose tube is not installed properly Follow instructions on page 9
Visible dirt
escaping from
cleaner
Dirt Tank is full of debris
Empty Dirt Tank
Filter is missing or installed
incorrectly
Check filter for correct installation
Dirt Tank installed incorrectly
Position tank correctly and
move lock button to the right until
it is in the center of the unit
Reduced
steam or
no steam
Water tank empty
Fill tank
Steam level not selected
Select steam level by pushing
steam level button
