6
With the cord plugged into an electrical outlet, turn the power
on and off by pushing or stepping lightly downward on the
Power Switch.
To extend the Power Cord for use, grasp the plug and gently pull
out from the vacuum cleaner. Your cleaner is equipped with an
Automatic Cord Rewind Button. When cleaning is finished, switch
off power and grasp the plug to disconnect from the electrical out-
let, then press the Automatic Cord Rewind button. The cord will
rewind automatically.
If the Full Bag Indicator turns to a red color while you are cleaning,
the dust bag needs to be replaced. If the Full Bag Indicator
continues to display the red color even after changing the dust
bag, turn the vacuum off and check whether the Hose, Suction
Tube or Nozzle is clogged.
Open the Dust Bag Compartment by depressing the lever
near the handle.
Remove the Dust Bag from the cleaner and seal it with
the closure tab provided. Dispose of the full bag.
Slide the cardboard bag collar of the replacement Dust
Bag into the bag holder. Make sure the Closure Tab is
not obstructing the Suction Inlet.
Press the Dust Bag Compartment door down gently until
it relocks.
NOTE: There must be a Dust Bag in the canister for
Dust Bag Compartment door to properly latch.
Pre-Motor Filter -
Open the Dust Bag Compartment.
Remove Filter to clean. The Pre-Motor Filter may be gently
cleaned by washing it in warm water with a mild detergent.
Allow Filter to completely dry before replacing it in its
original position. If Filter is torn, replace it with a new Filter.
Post-Motor Filter -
To open the Filter Cover, press front
tab and pull it simultaneously. Remove and replace the
Filter. Close the Cover.
1.
2.
Operating / Maintenance Instructions
1.
Power Switch
Cord Storage
Full Bag Indicator
Dust Bag Replacement
2.
3.
4.
Maintenance or Replacement of the Filter
WARNING:
Hold plug when rewinding the
cord onto the reel. Do not
allow the cord to whip when
rewinding.
Closure Tab
