background image

2

   global.BISSELL.com

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING YOUR MACHINE.

When using an electrical machine, basic precautions should be observed, including the following:

WARNING 

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:

• If the supply cable is damaged, it must be replaced by the 

manufacturer, its service agent or similarly qualified person in 

order to avoid a hazard.

• A hazard may occur if the machine runs over the supply cord.

• The machine has to be unplugged after use and before 

carrying out user maintenance on the machine.

• If your machine is fitted with a nonrewireable BS 1363 plug it 

must not be used unless a 13 amp (ASTA approved to BS 1362) 

fuse is fitted in the carrier contained in the plug. Spares may 

be obtained from your BISSELL supplier. If for any reason the 

plug is cut off, it must be disposed of, as it is an electric shock 

hazard should it be inserted into a 13 amp socket.

• If machine is not working as it should, has been dropped, 

damaged, left outdoors, or dropped into water; do not 

attempt to operate it and have it repaired at an authorized 

service center.

• Children should be supervised to ensure that they do not play 

with the machine.

• The plug must be removed from the socket-outlet before 

cleaning or maintaining the machine.

•  Floor slippery when wet.

• Use only the type and amount of liquids specified under the 

operations section of this guide.

• Always connect to a properly earthed electrical socket.  

Do not modify earthed plug.

• Do not use flammable or combustible liquids with this 

machine.

• If foam or liquid escapes from the machine, switch OFF 

immediately.

• Clean the water level limiting device regularly and examine it 

for signs of damage.

• This machine is not intended for use by persons (including 

children) with reduced physical, sensory or mental 

capabilities, or lack of experience and knowledge.

• Operators shall be adequately instructed on the use of  

these machines.

• This machine is not suitable for picking up hazardous dust.

• Do not leave machine when it is plugged in. Unplug from 

outlet when not in use and before servicing.

• Use indoors only.

• Always install float before any wet pick-up operation.

• Do not use for any purpose other than described in this user 

guide. Use only manufacturer’s recommended attachments.

• Do not pull or carry by cable, use cable as a handle, close door 

on cable, or pull cable around sharp edges or corners.  

Do not run machine over cable.

• Keep cord away from heated surfaces.

• Do not unplug by pulling on cable. To unplug, grasp the plug, 

not the cable.

• Do not handle plug or machine with wet hands.

• Do not put any object into openings. Do not use with any 

opening blocked; keep openings free of dust, lint, hair, and 

anything that may reduce air flow.

• Keep hair, loose clothing, fingers, and all parts of body away 

from openings and moving parts of the machine and its 

accessories.

• Turn OFF all controls before plugging or unplugging machine.

• Use extra care when cleaning on stairs.

• Do not use to pick up flammable or combustible materials 

(lighter fluid, gasoline, kerosene, etc.) or use in areas where 

they may be present.

• Do not pick up anything that is burning or smoking, such as 

cigarettes, matches or hot ashes.

• Do not use without filters in place.

• Do not turn your machine ON until you are familiar with all 

instructions and operating procedures.

• Keep machine on a level surface.

• Do not use machine in an enclosed space filled with vapours 

given off by oil-based paint, paint thinner, some  

moth-proofing substances, flammable dust, or other explosive 

or toxic vapours.

• Plastic film can be dangerous. To avoid danger of suffocation, 

keep away from children.

• Do not allow the supply cord to come into contact with the 

rotating brushes.

• Only use the socket outlet on the machine for purposes 

specified in the instructions.

SAVE THESE INSTRUCTIONS 

ORIGINAL INSTRUCTIONS. FOR OPERATION ON A 220-240 VOLT A.C. 50-60 HZ POWER SUPPLY ONLY. 

THIS MACHINE IS INTENDED FOR COMMERCIAL USE, FOR EXAMPLE IN HOTELS, SCHOOLS, HOSPITALS, 

FACTORIES, SHOPS, OFFICES AND RENTAL BUSINESSES.

IMPORTANT INFORMATION

To reduce the risk of a leaking condition, do not store where freezing may occur. Damage to internal components may result.

SYMBOL

EXPLANATION

Caution.

Read operator’s manual.

Risk of fire.

Risk of electric shock.

SYMBOL

EXPLANATION

For indoor use only.

Protection against moving parts.

Risk of automatic start-up.

Use warm water, temperature up 

to 60°C.

SYMBOL

EXPLANATION

Do not overwet carpet. Use only on carpet 

moistened by the cleaning process.
Use only BISSELL® cleaning formulas 

intended for use with this machine.

Содержание CROSSWAVE COMMERCIAL 3388 Series









Отзывы: