6
BISSELL.com
Cleaning the Pre-Motor Filter
Find replacement filters at
BISSELL.com
.
24h
1.
Press the tank release
button and pull out to remove
dirt tank.
2.
Remove carbon and foam
filter from lid.
3.
Hand wash in warm water
and rinse well; mild detergent
may be used if desired. Let dry
completely before reinstalling.
4.
Reinstall filters. The carbon
filter should be on top of the
foam filter.
5.
Return tank back on
vacuum and press firmly until
it clicks into place.
WARNING
»
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or
troubleshooting checks.
»
Do not operate vacuum with damp or wet filters or without all filters in place.
Replacing the Brush Roll and Belt
For additional support videos and information, visit
support.BISSELL.com
.
1.
Unplug vacuum, turn over
and unscrew six (6) Phillips-
head screws to remove the
bottom cover. Lift brush
straight out.
2.
Clean debris from brush
roll. Inspect by placing on its
end and spinning. The brush
roll should spin freely, multiple
times by one flick. If it doesn’t,
replace brush roll. Check belt
for wear or cuts and replace if
necessary.
3.
Replace the brush roll and
belt by looping the belt over
the motor shaft and the brush
roll. Line up the endcaps and
pull the brush forward into
place. This will stretch the belt.
Return bottom cover back on
and replace the screws.
