w w w. b i s s e l l . c o m
A
ssembly
1.
Connect hose to vacuum by inserting
hose connector on the end of the hose
into the suction inlet. make sure the hose
is positioned so the tabs on the hose
connector line up with the notches on
the suction inlet. once inserted into the
suction inlet, turn counter clockwise to
lock into place.
2.
Attach extension wands section together
by inserting into one another and
twisting slightly to tighten.
3.
Connect hose handle to the end of
the extention wand and twist slightly
to tighten.
4.
Connect floor nozzle to the end of
the extension wand and twist slightly
to tighten.
5.
once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor
nozzle) into the storage slot on the
rear of the vacuum.
Power cord
the power cord is located at the rear
of the vacuum. gently pull out the
power cord, watching for the yellow
line. stop pulling the power cord once
the yellow line is visible. there is also
a red line, which indicates the end of
the usable cord. do not pull the
power cord out beyond the red line.
automatic cord rewind
your vacuum is equipped with an
automatic cord rewind. When cleaning
is finished, press the power button off
and grasp the plug to disconnect from
the electrical outlet. Hold the plug and
press the automatic cord rewind button
to rewind the cord automatically.
Power button
turn the power on or off by pressing
lightly downward on the power button
( ).
5
WaRning:
Plastic film can be dangerous. To
avoid danger of suffocation, keep
away from babies and children.
O
perations
caution:
Be careful to avoid injury as cord
retracts very quickly.
caution:
Before using your vacuum,
make sure that the dirt cup and
all filters are in place. Do not
operate your vacuum without
the dirt cup and filters.
1.
5.
4.
3.
2.
suction Inlet
Automatic Cord
Rewind Button
colours may vary
from models shown
Power
Button
