w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
the only tool you’ll need to assemble
your vacuum cleaner is a phillips head
screwdriver.
attach handle to vacuum
1.
Locate the vacuum handle and remove
the screw packet taped to the base of
the handle.
2.
Stand the vacuum upright and slide
the base of the handle firmly into the
grooves at the top of the vacuum body.
3.
Check to be sure the handle is fitted to
the vacuum body. If there is a gap in
front, continue to push firmly until the
handle is flush.
4.
Insert the two screws from the screw packet
into the existing holes. Tighten securely with
a screwdriver.
attach vacuum hose and tools
1.
Line up the tabs on the base of the Twist n'
Snap hose with corresponding notches.
2.
Slide the end of the hose grip onto the
hose grip base. Place the hose into the
hose clip.
note: the powerfoot will not
operate effectively unless the hose
is firmly attached to the base.
3.
Snap the telescoping extension wand,
crevice tool, and combination tool into
storage clips as shown.
4.
The Pet TurboEraser Tool snaps on to the
holder on the front of the handle. Place
the Pet TurboEraser Tool in the holder by
hooking the bottom onto the tab and
pushing the top of the Pet TurboEraser
Tool into place.
5
2.
4.
1.
2.
WaRning
:
Plastic film can be
dangerous. To avoid
danger of suffocation, keep
away from babies and children.
Combination
Tool
Telescoping
Wand
Crevice Tool
Pet
TurboEraser™
Tool
3.
4.
