Attach vacuum hose and tools
1.
Line up the tabs on the base of the Twist ‘n
Snap hose with the corresponding notches
on the hose collar as shown.
2.
Turn the Twist ‘n Snap hose to the
left
to lock the hose into place.
3.
Connect the curved hose wand to the hose.
Grasping the curved hose wand, slide the
end of the curved hose wand onto the hose
wand base. Snap the hose into the hose clip.
NOTE: The vacuum will not operate effectively
unless the curved hose wand is firmly attached.
4.
Slide the extension wand and crevice tool
together into the storage clip.
5.
Slide the dusting brush/upholstery tool into
the storage clip.
6.
Attach the Pet Contour Tool by aligning the
slots at the bottom with the tabs on the
upper tank cap, then snap back into the two
posts to secure.
7.
Store Pet TurboBrush on the front of the
handle by lining up the TurboBrush base with
the base of the holder, then push back to
snap into place.
8.
Flip the Pet Hair Lifter down until it clicks
into place on the front of the foot.
NOTE: Flip the Pet Hair Lifter down for carpeted
surfaces and up for non-carpeted surfaces (see
page 7 for more information).
Power switch
The Power Switch is located just below the
handle on the front of the vacuum. Push the
rocker switch “ON” (I) to vacuum, and “OFF” (O)
when cleaning is complete.
A
ssembly
6
w w w . b i s s e l l . c o m
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate but
is raised above floor. To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward.
CAUTION:
To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.
O
perations
CAUTION:
Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and HEPA post-
motor) are in place. Do not
operate your vacuum
without these filters.
1.
Twist 'n
Snap Hose
6.
7.
8.
Pet Hair Lifter
ug110-4048_3920E_508.indd 6
ug110-4048_3920E_508.indd 6
5/7/08 3:56:55 PM
5/7/08 3:56:55 PM
