Mounting & installation
continued
concrete Wall (fasteners not included)
you will need; (4) 3/8” x 2-1/4” concrete sleeve
anchors.
1
. Drill a 3/8” x 1-3/4” hole with a masonry drill bit.
2
. Insert a bolt and anchor sleeve into the hole.
3
. Align the bracket over the hole and mark
remaining hole locations using the (4) outer
holes of the mounting bracket; remove
bracket and drill remaining holes.
4
. Mount the bracket starting at top corner hole,
tightly securing sleeve anchor with hex nut.
5
. Repeat for three remaining holes.
6
. Mount the unit by making sure the two
square slots on backside of unit are sitting
on the two hooks on the mounting bracket.
Mounting the Hose Holder (fasteners included)
1
. Determine desired location for hose holder
and screw 1-1/4” screw into stud.
(If mounting into drywall with no stud
available, use supplied drywall anchors)
2
. Hang holder from screw and insert 2-1/2”
screw in bottom hole of hose holder to finish
mounting.
3
. Wrap hose around holder.
Power switch
the power switch is located on the top left side
of the vacuum.
to turn vacuum on, ( I ) press up.
to turn vacuum off, ( o ) press down.
A
ssembly
O
peration
6
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
WaRnInG:
Do not remove
plastic covering on
power switch.
Slots
Use (4) Outer Holes
To Mount Bracket
Power Switch
ug110-4053_18P0_608.indd 6
6/13/08 12:35:29 PM
