Bisonte PC100-H, Руководство пользователя

Страница: 74 / 82

–
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
74
7.6 SHUTDOWN
To stop the engine in an emergency, turn the stop switch to the OFF
position. Under normal conditions, use the following procedure:
6-1. Set the speed control lever at the low speed position and allow
the engine to run at low speed for 2 or 3 minutes before stopping.(
Fig-11)
6-2.Tum the stop switch to the OFF position.(Fig-12)
6-3.Close the fuel cock. (Fig-13)
7.7 SERVICE&STORAGE
CAUTION
Flammable liquid: Stop engine and to not smoke or allow work in
immediate area when refueling. Fire or explosion could result from
flames or sparks. Moving parts: Shutdown engine before performing
service or maintenance. Contact with moving parts can cause
serious injury. High temperature: Allow machine and engine to cool
before performing service or maintenance. Contact with hot
components can cause serious burn.
7-1. Daily Service A. Remove mud, dirt, etc, from the unit. B. Clean
bottom face of the vibrating plate. C. Check the air cleaner element
and clean if necessary. D. Check all nuts, bolts, and screws for
tightness and re-tighten as necessary.
7-2. Weekly Service A. AIR CLEANER SERVICE (Fig-14) Dirty air cleaner
element will cause starting difficulty, power loss, engine
malfunctions, and shorten engine life extremely.
- 12 -
Keep the air cleaner element clean. URETHANE FOAM ELEMENT
Remove the element and wash it in kerosene or diesel fuel. Then
saturate it in a mixture of 3 parts kerosene or diesel fuel and 1 part
engine oil. Squeeze the element to remove the mixture and install it
in the air cleaner. URETHANE FOAM DUAL STRUCTURE 1. Clean the
urethane foam in the same way as described above. 2. Wash the
element in kerosene or diesel fuel. Saturate it in a mixture of 3 parts
kerosene or diesel fuel and 1 part engine oil. Shake off excessive oil.
B. Remove spark plug, clean and adjust the spark plug gap to
0.6-0.7mm(0.02-0.03 in.). (Fig-15) C. Drain the motor oil of the engine
and replace with new specified oil. (Fig-16)
NOTE: When the engine is new, the
first oil change must be made after 20 hours of operation and
replenish the oil tank before operating.
7-3. Monthly Service Change the oil in the vibrator assembly.
7-4. Storage When storing the compactor for long periods after
operation. A. Thoroughly drain the fuel from the fuel tank fuel pipe
and carburetor. B. Pour a few drops of motor oil into the cylinder by
removing the spark plug. Rotate the engine several times by hand so
that the cylinder interior is covered with oil. C. Clean the outer
surface of the machine with an oil moistened cloth. Cover the unit
and store in a humidity-free area.