Bisonte BTA-12SDE, Руководство пользователя

Страница: 95 / 109

Ⅳ
. Starting
( Note: the shift bar must be on the neutral position)
1. Start the diesel engine according to the procedures stipulated in the instruction manual for
the diesel engine.
2. The diesel engine should run at a low speed (1500-2000 rpm) under no load for 2-3
minutes.
3.
Check whether the diesel engine runs normally or not. If it is abnormal, stop the engine
and have a check.
Ⅴ
. Operation (Note: breaking-in must be performed before the use of power tiller, see the
breaking-in method in chapter Four)
1. Using a slow shift
①
The left hand grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pulls the shift bar backwards, make sure the shift casing locates in the slow
shift position, and observe whether it reaches the right position or not. Then the right hand
grasps the right handle.(Note: do not grasp the reversing bar)
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller can
run at a slow speed.
④
The right hand increase the throttle properly, the motor can run at a speed of 5 km/h
2.
Using a fast shift
①
The left hand grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pushes the shift bar forwards, make sure the shift casing locates in the fast
shift position, and observe whether it reaches the right position or not. Then the right hand
grasps the right handle. (Note: do not grasp the reversing bar)
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller can run
at a fast speed.
④
The right hand increase the throttle properly, the motor can run at a speed of 10 km/h.
3.
Using a receiving shift
①
The left hand pulls grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pulls or pushes the shift bar to the neutral shift and observe whether it
reaches the right position or not. The forefinger of right hand grasps the trigger of the
reversing shift first, then the right hand grasp the reversing handle.
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller can run
backwards.(Note: do not loosen the reversing handle)
④
When the backward running of the machine is not needed, the left hand holds the clutch
handle gradually, and the right hand loosens the reversing handle.
4. Shift when the machine is running, reduce the oil valve of the diesel engine (but subject to
the diesel engine’s not quenching), then makes the clutch separated. When the machine
stops running, then shift.
5. Change directions: pull the handle to left or right to make the machine turn left or right.
(Note: pulling the wrong handle may lead to damage to the gears)
6.
The operation method of recoil/electric starter and safety device
①
Left hand close upon the red emergency stop handle with the handle bar; draw back the
clutch handle with your middle finger and ring finger at the same time. The above two
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
95