Paseo /
Rapid 2
24
Charging for the first time:
To charge the batteries to their maximum capacity proceed as follows:
• Discharge the factory-charged batteries until the LED display
shows two bars.
• Charge the batteries as described below (approx. 16 h).
• Discharge the batteries again to two bars on the LED indicator.
• Finally charge the batteries as described.
Use only approved battery chargers to charge the batteries (see
Technical Data). See the instructions for use for the battery charger.
• Before switching on the battery charger, check that the power
supply is 230V.
• Switch off the scooter first.
• Connect the battery charger to the scooter. The charging jack is
on the side of the steering column and is covered with a cap
(unscrew) for protection.
• Plug the mains plug of the battery charger into the mains soc-
ket (230 V) and switch on the charger.
• The charge indicator of the battery charger shows the status of
the charging process.
Red – battery charger is switched on
Yellow – charging
Green – charging completed (batteries charged)
• Pull out the mains plug when charging is complete and discon-
nect the battery charger from the scooter.
Be very careful when working on the batteries. Do not use metal
tools, do not touch the battery terminals and follow the battery
manufacturer's instructions.
Caution! This work should only be done by a trai-
ned technician. There is danger of fatal injury.
6.4.1 Charging
Fig. 18
Fig. 19
6.4.2 Replacing batteries
