BIRO Mini-32, Руководство по эксплуатации и обслуживанию, Страница: 8 / 32

5
11. Turn the toggle hand/foot selector switch to the hand position and move the Auger Engage Lever to
“Grind”to activate the grinding drive shaft. Push the green start button. CHECK THE ROTATION OF
THE AUGER DRIVE SHAFT; ROTATION MUST BE COUNTER-CLOCKWISE
as indicated by
the rotation decal affixed to the grinding bowl.
ONLY HAND TIGHTEN END RETAINING RING
15. Check placement of all warning labels and be sure anyone who is to operate this MINI-32 MIXER
GRINDER has read and fully understands the manual. Machine is now ready for trained operators to
process product.
16. Use meat deflector attached to grinding bowl to eliminate meat splatter.
17. Contact your local distributor if you have any questions or problems with the installation or operation of
this machine.
12. If machine runs clockwise(backwards), it must be rewired to correct rotation, otherwise serious
irreparable damage may occur to the grinding components.
PRE-OPERATION AND AUGER ROTATION CHECK
ROTATION MUST ONLY BE CHECKED WITH THE
GRINDING AUGER REMOVED, otherwise serious irreparable
damage may occur to grinding components.
13. Check operation of optional footswitch if equipped. Plug footswitch cord into fitting on control panel.
Turn selector to foot. The machine will operate with pressure on the footswitch treadle. Releasing the
treadle stops the machine.
14. Insert auger assembly into the grinding bowl and fully engage the auger into the drive shaft. Place knife
first (sharp edges out) then grinding plate into end of grinding bowl. The grinding plate slides over the
knife drive pin, and is held from rotating during operation by three pins in the grinding bowl. Install the
end retaining ring.
For best results, use knife and plate as a set. Do not operate machine
for any period of time without product in the grinding bowl. This will
cause heating and dulling of the knife and plate.
10. The start/stop switches and the grind engage lever are located on the right side of the machine when facing
the grinding bowl. The start switch will activate the mixer paddles. The start switch will also activate the
grinding auger, only when the grind lever is in the engaged, or in the grind position. The stop switch will
stop operation. To deactivate the grinding operation move the grind lever to the disengaged, or to the mix
position. The tank and hopper cover interlock switches are located in the motor compartment. When the
safety cover is raised the machine will stop operation.