BIRO EMG-32, Руководство по эксплуатации и список запасных частей

Страница: 19 / 40

17
CLEANING
TO AVOID SERIOUS PERSONAL INJURY
• ALWAYS Turn Off, Unplug Machine From Power Source and Perform Lockout/Tagout
Procedure to this Machine BEFORE Attempting to Unjam or Unclog, Cleaning or Servicing.
• ONLY Use Recommended Cleaning Equipment, Materials, and Procedures.
• NEVER
Spray Water or Other Liquid Substances Directly at Motor, Power Switch or any Other
Electrical Components.
• ALWAYS Thoroughly Clean Equipment at Least Daily.
CLEANING THE EMG-32 MIXER-GRINDER
l. Disconnect mixer grinder from power-source and perform lockout/tagout procedures.
2. Remove grinding bowl end ring, breaker plate, knife and grinding auger.
3. Remove mixing paddles by first loosening the wing nuts locking the mixing paddle from hubs. Turn the
front hubs clockwise and remove from front of machine. Slide mixing paddles forward off the drive shafts
and remove the mixing paddles from the machine.
DO NOT POWER SPRAY DIRECTLY AT ELECTRICAL COMPONENTS
4. Machine is now ready to be cleaned using warm soapy water and rinsed with clean water. Machine may be
cleaned by power spray washing, taking care not to spray directly at any electrical controls.
5. The grinding bowl can be removed for cleaning if desired. This is accomplished by removing the three nuts
on the flange of the grinding bowl.
6. After machine has been cleaned and allowed to air dry, all exposed metal surfaces should be coated with a
good food grade light oil or grease.
7. Never wash the clear product mixer safety cover with any type of abrasive cleaners. Use a soft cloth and
warm soapy water only, rinse with clear water, let air dry.
8.
CLEANING PROCEDURE FOR THE POLYCARBONATE SAFETY COVER:
By using compatible cleaners, coupled with proper maintenance techniques will significantly improve the
material’s service life.
A. Rinse with water to remove excess dust and dirt.
B. Wash with soap or mild detergent using a sponge or soft cloth.
C. Rinse thoroughly with clean water.
D. Dry with a soft cloth or chamois to prevent water spots.
COMPATIBLE CLEANERS:
Formula 409, Palmolive liquid - 3, Tob Job, Joy - 2, Windex with Ammonia D-4.
1. Do not use abrasive cleaning materials, such as brillo pads or metal scrapers. Tin is a soft metal and should
be cleaned with a soft cloth and dried.
2. Do not use a cleaning agent containing a high percentage of free alkali or acid.
3. Do not use a detergent containing a high percentage of tri-sodium phosphate or meta-silicate.
Tin is reactive to both.
4. Rinse well and dry thoroughly after washing to remove agents that may be reactive to tin.
5. If sterilizing agent containing chlorine is used, the tinned surface must be thoroughly rinsed.
Chlorine is corrosive to tin.
6. Dry thoroughly after rinsing and store in a dry environment.
7. If water is exceptionally hard, drying will be necessary to prevent spotting.