BIRO 722, Руководство по эксплуатации и обслуживанию

Страница: 6 / 16

8. If machine runs clockwise (backwards), it must be rewired to correct rotation, otherwise serious irreparable
damage may occur to grinding components.
ONLY HAND TIGHTEN RETAINING RING
For best results, use knife and plate as a set. Do not operate machine for any period of time without
product in the grinding bowl. This will cause heating and dulling of the knife and plate.
10. Check placement of all warning labels and Manual. Machine is now ready for trained operators to process
product.
11. Contact your local Distributor or BIRO directly if you have any questions or problems with the
installation or operation of this machine.
MOTOR WIRING AND ELECTRICAL REQUIREMENTS
(1) Interchange of current is made in motor outlet box. Leads are properly marked. Changing instructions
are on the motor plate or motor outlet box.
(2) All grinders are wired for the voltage as ordered. Be sure motor specifications (voltage, cycle, phase)
match power supply line. Be sure line voltage is up to specification.
(3) Electrical connections to be in accordance with safety codes and National Electrical Code.
(4) Rated voltage of the unit shall be identical with full supply voltage.
(5) Voltage drop on the supply line shall not exceed 10% of full supply voltage.
(6) The feederline conductor size in the raceway from the branch circuit to the unit must be correct to
assure adequate voltage under heavy starting and short overload conditions.
(7) The BIRO Manufacturing Company is not responsible for permanent wiring, connection or
installation.
NOTE TO OWNER AND ELECTRICIAN: IF THIS MACHINE IS NOT CORD
AND PLUG CONNECTED TO THE ELECTRICAL SUPPLY SOURCE, THEN IT
SHOULD BE EQUIPPED WITH, OR CONNECTED TO, A LOCKABLE,
MANUALLY-OPERATED DISCONNECT SWITCH (OSHA 1010.147).
4
UNCRATING AND SET UP - CONTINUED
9. Check that the grinding bowl is properly seated and that the bowl lock assembly is tight. Insert worm
assembly into grinding bowl, place knife (sharp edges out) onto the square end of the knife drive pin.
The breaker plate slides over the worm knife drive pin, and is held from rotating by a pin in the grinding
bowl. Put on the retaining ring.