Installation/Mounting: Screw mounting bracket (pictured, right) onto the screw thread of
the laser unit, threading the power cord through the center hole. Secure mounting bracket
to desired surface with screws appropriate for the surface (metal, wood, concrete etc.).
Adjust the angle as needed. Do not stare into the beam or look into it with any optical
instrument. Turn it away from human sightlines.
The unit must be properly earthed. Outdoor electrical outlets should be fully waterproof.
Use in a well-ventilated area. Do not block any ventilation slots. If desired, block unwanted beams (the beams
that would normally point
down
, for example), by adjusting the thumbscrews on the metal “door” covers on the
front aperture.
Laser Automatic Cycling
The Bird-X Laser has been pre-programmed to prevent acclimation of the pests to an unchanging stimulus. This
consists of a cycle of ON / OFF operation with intervals varying between 5 and 15 minutes OFF time for every 5
minutes ON. This cycle will be maintained as long as the Bird-X Laser is in operation.
First Time Use:
To turn on the Bird-X Laser:
1. The remote control may be used to turn the unit off and on, and also to operate for specified durations (2,4,6
or 8 hours). One remote will control multiple units (within its coverage range – if units are mounted at a distance
from one another, the remote must be activated close enough to each unit for the signal to reach it.)
Remote Control & On-Unit Control including Timer Operation:
The unit operation can be controlled in a number of ways:
•
Direct
•
Remote Control. The unit may be switched on and off using the remote control
provided. This Radio Frequency remote has a range of approximately 65 feet.
Pull out the antenna to boost signal in case of greater distance or
obstructions.
•
Timed operation (using the remote control).
2. Insert the battery into the Remote control. Remove the battery if the Remote will
not be used for a long time; this will conserve battery life.
To use the timer, press the remote’s TIMER ON button. Unit will flash twice to show it has received the signal.
Pressing the TIMER ON button defaults to 2 hours of operation. To select a different duration, press the desired
hour button following Timer START. To cancel timer operation, press the TIMER OFF button. Unit will flash twice
to show it has accepted the signal.
CARE/CLEANING