1.
This could be due to a long time of operation without a break, or a high operating
temperature, neither of which is recommended. If this is occurring in a normal temperature
environment with periodic breaks, try turning off the unit to cool for 30 minutes before
turning it on again. After 5 minutes (longer in cold weather) the beam should no longer be
weak/fuzzy.
2.
This could be due to a dirty mirror. Check mirrors and clean (according to “cleaning”
section).
n
If problems cannot be solved please contact your dealer for service
In particularly stubborn and/or long-term infestations, it may be necessary to consider a
combination approach to further decrease the desirability of the facility to birds. Please see the
SYNERGY AND OTHER PRODUCTS section below.
Housekeeping is very important! As mentioned in the Bird Management Program, the problem area
should be cleaned of all evidence of birds. Nest, fledglings, droppings, dead birds, and the residual
scent should all be removed. Check the area for unusual incentives. Remove food spillage,
garbage, nesting materials and other items that may be appealing to birds.
VIII.
PRECAUTIONS
Safety Labels
Bottom
Front Panel
n
Never look directly into laser beams, or into the specular reflection(s) of any beam. Wear
safety goggles to protect your eyes when necessary.
n
Wear antistatic wrist strap while servicing to prevent electrostatic damage.
n
Do not spill liquids into or onto unit. If this happens, disconnect the power immediately.
n
Power directly off of a switched circuit; never with a dimmer or rheostat (even a 0 to 100%
switch).
n
Disconnect unit from main power before inspecting, installing, making any type of connection,
or replacing any components.
n
Locate this unit in a place with adequate ventilation at least 15 cm from a wall, and mount it in
a safe, stable manner.
n
To prevent fire or shock hazard, do not expose this unit to a high temperature or high humidity
area. Unplug unit when not in use.
n
Keep combustible materials away.
n
Do not place unit in or near water. Do not mount while standing in or surrounded by water.
Laser aperture & aperture label
Identification label
Certification label
Warning label
