4
Bircher Reglomat AG,
Wiesengasse 20, CH-8222 Beringen, www.bircher-reglomat.com
OK?
Klick
➔
➔
2x
2x
3V
LITHIUM
CR 2032
+
3V
LITHIUM
CR 2032
+
3V
LITHIUM
CR 2032
+
3V
LITHIUM
CR 2032
+
9
Technical data
10
Standards EN ISO 13856-2 and EN ISO 13849-1
11
EC-Declaration of Conformity
12
Contact
/ Danish seller
System
Frequency bands
868.95 MHz & 869.85 MHz
Range
Under optimum conditions up to 100 m
Pollution degree
2
Working temperature
-20 °C to +55 °C
Transmitter 1
Battery power
2 x Lithium 3 V Type CR2032
Power consumption
Transmitting: 17 mA, standby: 16 µA
Protection class IEC 60529 IP54
The AirMission 2.W2 system itself is not able to check the function of the
sensor in response to a pressure pulse. In accordance with D 3.5 of
EN ISO 13856-2, a pressure wave system according to category 2 of
EN ISO 13849-1 can be designed by checking the pressure wave system
Manufacturer:
Bircher Reglomat AG, Wiesengasse 20, CH-8222 Beringen
Following directives have been observed:
MD 2006/42/EC, RoHS 2011/65/EU, RED 2014/53/EU
EC type-examination certificate:
E6945
Notified inspection centre:
Suva, technology division, SCESp 0008, ID no. 1246
Product variants:
AirMission 2.x
Receiver
Supply voltage
12/24 V ACDC
Transmitter memory
7 + 7
Output
2 relays 24 V, 0.5 A; micro-disconnection 1B
Power consumption
0.5 W @ 12 V; 1.2 W @ 24 V
Test signal input
12/24 VACDC
Protection class IEC 60529 IP55
Transmitter 2
Battery power
2x Lithium 3 V type CR2032
Power consumption
Transmitting: 17 mA, standby: 16 µA
Protection class IEC 60529 IP65
at every machine cycle. On the doors and gates the door/gate control
must assure this function in order to satisfy category 2. (
➔
Figure A.4 of
EN ISO 13856-2).
7
Battery change
1.
Open
2.
Carefully pull out
PCB
3.
Replace both
batteries
(front/back)
4.
Slide PCB back into
housing
5.
Close
6.
System test:
Activate safety edge
Click
7.2 Transmitter 2
7.1 Transmitter 1
8
Alternative installation with double sided tape (not supplied)
Caution!
Ensure surfaces are clean, dry and free of dust and grease.
Double-sided
adhesive tape
View of transmitter 2
(bottom)
Swissdoor ApS
,
Stenhuggervej 2, DK-5471 Soendersoe, Denmark, Tel.: +45 86 28 00 00, [email protected], www.swissdoor.dk
