70
23
-0
6-
00
04
c
06
/0
9
Bircher Reglomat AG, Wiesengasse 20, CH-8222 Beringen, Switzerland, www.bircher-reglomat.com
Technical data
8
Contact data
7
Declaration of conformity
Programming
4
6
Manufacturer: Bircher Reglomat AG, Wiesengasse 20, CH-8222 Beringen, Switzerland, declares
if used according to manufacturer's specifications, fulfills the fundamental requirements in acc. with Machinery directive 98/37/EC and EMC directive 2004/108/EG
with following standards: EN 300 220, EN 301 489, EN 60730, EN 954-1 (Cat. 2)
Receiver
Transmitter
Supply voltage
12 /24 VAC DC
Supply voltage
2x lithium battery 3 V DC
type CR2032 suitable for
down to -20°C
Transmitter memory
10
Output
Relay, 24V, 0,5A,
micro disconnection 1B
Power
consumption
0.5 W @ 12 V,
1,2 W @ 24 V
Power
consumption
When transmitting: 17 mA,
in standby: 16
µ
A
Rated Transient
Over Voltage
330 V
Testing signal (Input)
or
General
Dimensions
130 x 35 x 15 mm
Working temperature
- 20°– +55° C
Range
> 10 m
Software
Class A
Frequency bands
868.95 MHz & 869.85 Mhz
Protection class
acc. to IEC 60529
IP 55
Pollution degree
2
Ball pressure test
acc. to IEC 695-10-2
PCB:
125° C
Wrap:
75° C
Installation
5
A minimum distance of 1 m must be observed between the transmitter and receiver.
1. Install transmitter on gate. Please note: cable outlet at bottom!
2. Wire safety edge to transmitter.
3. Install receiver and wire to control unit.
The devices RFGate transmitter and RFGate receiver must be mounted on separate surfaces.
Transmitter functions
Setting
DIP-switch
Description
Safety edge type
Safety edge
resistance
1
1
2
2
ON
ON
Standard safety edge resistance 8.2 kohm
Safety edge
contact
1
1
2
2
ON
ON
Safety edge (NO, without terminating resistor)
➔
no safety category 2!
Transmitting frequency
Frequency 1
2
2
1
1
ON
ON
Setting MUST match that of receiver, Frequency 869,85 MHz
Frequency 2
2
2
1
1
ON
ON
Setting MUST match that of receiver, Frequency 868,95 MHz
*
*
*
Factory settings
Activate programming mode
Receiver:
Activate programming mode
Store transmitter code (Programming mode has to be activated)
Store transmitter code
Store additional transmitter codes
Reached maximal amount of transmitters (10)
(Transmitter memory full)
Finish programming
Reset
1.5 s
1.5 s
1.5 s
release
release
release
Receiver:
1 x Beep
Receiver :
1 x Beep
10 sec Beep
Receiver :
2 x Beep
Delete all stored codes
(Receiver)
3.5 s
1.5 s
Receiver :
Receiver :
Wait 10 sec
1 x Beep
release
Receiver :
1 x Beep
Receiver :
Series of
Beeps
...
...
Receiver :
Receiver:
Transmitter:
Transmitter:
Receiver:
Transmitter:
Transmitter:
Transmitter
Safety edge
4. Switch on voltage.
5. Carry out test by actuating the connected safety edge in different gate positions, particularly the open and closed positions.
7
6
7
6
npn
open
collector
