Biostar
T-Series
TForce
6100-939/
TForce
6100
User’s Manual
6
B. Connectors and Headers:
How to setup Jumpers
The illustration shows how to set up jumpers. When the jumper cap is placed on pins,
the jumper is “closed”, if not, that means the jumper is “open”.
Pin
opened
Pin
closed
Pin1-2
closed
Memory Voltage Header: JDDR_OV>3V
When processing Memory voltage overclocking, please place the jumper to
pin1-2 closed. The default setting is pin2-3 closed.
JDDR_OV>3V
3
1
1
3
TForce 6100-939
TForce 6100
1
3
3
1
Pin 1-2 Close
1
3
3
1
Pin 2-3 Close (Default)
Note:
1.
When “JDDR_OV>3V” jumper cap is placed on Pin 2-3, memory voltage can be manually
adjusted under CMOS setup.
2.
When “JDDR_OV>3V” jumper cap is placed on Pin 1-2, memory voltage will be fixed at
3.3V automatically, and can’t be adjusted under COMS setup.
3.
Before setting memory voltage overclocking, please ensure that your DDR supports up to
3V. (Consulting your DDR supplier)
LED Indicators and Buttons
There are 4 LED indicators on the motherboard to show system status.
TForce 6100-939
TForce 6100
PWRSW1
RSTSW2
LED_D1
LED_D2
LED_DIMM
LED_PWR
PWRSW1
RSTSW2
L
E
D_D1
L
E
D_D2
L
E
D_DIM
M
LE
D
_
5S
B
LED_D1 and LED_D2:
These 2 LED indicate system power on diagnostics.
Please refer to the table below for different messages:
LED_D1 LED_D2 Message
ON ON Normal
ON OFF Memory
Error
OFF ON
VGA
Error
OFF
OFF
CPU / Chipset Error
LED_DIMM:
This LED indicates the voltage of memory is activated normally.
LED_5SB/LED_PWR:
This LED indicates the system is ready for Power-on.
PWRSW1:
This is an on-board Power Switch button.
RSTSW2:
This is an on-board Reset button.
