By choosing “Auto” the system BIOS will the AGP output Buffer Drive strength
P Ctrl by AGP Card. By choosing “Manual”, it allows user to set AGP output
Buffer Drive strength P Ctrl by manual.
The Choices: Auto
(default), Manual.
AGP Driving Value
While AGP driving control item set to “Manual”, it allows user to set AGP
driving.
The Choices: DA
(default).
AGP Fast Write
The Choices:
Enabled,
Disabled
(default).
AGP Master 1 WS Write
When Enabled, writes to the AGP (Accelerated Graphics Port) are executed with
one wait states.
The Choices: Disabled
(default), Enabled.
AGP Master 1 WS Read
When Enabled, read to the AGP (Accelerated Graphics Port) are executed with
one wait states.
The Choices: Disabled
(default), Enabled.
AGP 3.0 Calibration cycle
The Choices: Disabled
(default), Enabled.
AGP Share Memory Size
The Choices: 64M
(default), Disabled.
CPU & PCI Bus Control
If you highlight the literal “Press Enter” next to the “CPU & PCI Bus Control” label and
then press the enter key, it will take you a submenu with the following options:
CPU to PCI Write Buffer
When enabled, up to four Dwords of data. Can be written to the PCI bus without
interrupting the CPU. When disabled, a write buffer is not used and the CPU
read cycle will not be completed until the PCI bus signals that it is ready to
receive the data.
The Choices: Enabled
(default), Disabled.
PCI Master 0 WS Write
When Enabled, writes to the PCI bus are executed with zero-wait states.
The Choices: Enabled
(default), Disabled.
PCI Delay Transaction
The chipset has an embedded 32-bit posted write buffer to support delay
15
