Biostar P4TCA PRO, Описание

Страница: 10 / 29

8
Installing DDR Module
1. Unlock a DIMM slot by pressing the
retaining clips outward. Align a DIMM on
the slot such that the notch on the DIMM
matches the break on the slot.
.
2. Insert the DIMM vertically and firmly into
the slot until the retaining chip snap back in
place and the DIMM is properly seated.
Serial Raid
Setting Up a RAID 0 System
The following steps lead you to build a RAID 0 system:
1. Enter System BIOS Setup; ensure that Intel RAID Technology is enabled. When
done, exit Setup.
2. Upon re-boot you will see the Intel RAID BIOS status message on the screen –
press CTRL+I to enter the Intel® RAID Option ROM user interface. Within this UI
select option #1 ‘Create RAID Volume’. Enter a volume name, press enter, select
the strip size (128KB is the default), press enter, press enter again, then press ‘Y’
to confirm. Once this is done, exit the Option ROM user interface.
3. Begin Windows XP Setup by booting from the installation CD.
4. At the beginning of Windows XP Setup, press F6 to install a third-party SCSI or
RAID driver. When prompted, insert a floppy disk containing the Intel RAID driver.
After reading the floppy disk, the Intel® 82801ER SATA RAID Controller’ will be
presented
—
select this driver to install.
5. Finish the Windows XP installation and install all necessary drivers.
6. Install the Intel Application Accelerator RAID Edition 3.0 software via the CD-ROM
included with your motherboard or after downloading it from the Internet. This will
add the Intel Application Accelerator RAID Edition 3.0 user interface utility that can
be used to manage the RAID configuration.