Biostar M6TSU, Руководство пользователя

Страница: 57 / 109

Chapter 2 BIOS Setup
2-22
When enabled and after the set time of system inactivity , the hard disk drive will
be powered down while all other devices remain active.
The Choices: Disabled (default), 1Min, 2Min, 3Min, 4Min, 5Min,
6Min, 7Min, 8Min, 9Min, 10Min, 11Min, 12Min, 13Min, 14Min,
15Min.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has “hung.”
The Choices: Delay 4 Sec, Instant-Off (default).
Wake-Up by PCI card
When you select Enabled, a PME signal from PCI card returns the system to Full
On state.
The Choices: Disabled (default), Enabled.
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming
call on the modem) awakens the system from a soft off state.
The Choices: Enabled (default), Disabled.
PWRON After PWR-Fail
This field determines the action the system will automatically take when power is
restored to a system that had lost power previously without any subsequent
manual intervention. There are 3 sources that provide current to the CMOS area
that retains these Power-On instructions; the motherboard battery (3V), the Power
Supply (5VSB), and the Power Supply (3.3V). While AC is not supplying power,
the motherboard uses the motherboard battery (3V). If AC power is supplied and
the Power Supply is not turned on, 5VSB from the Power Supply is used. When
the Power Supply is eventually turned on 3.3V from the Power Supply will be
used.
There are 3 options: “Former-Sts”, “On”, “Off”.
“Former-Sts” (default) Means to maintain the last status of the CMOS
when AC power is lost.
“On” Means always set CMOS to the “On” status when
AC power is lost
“Off” Means always set CMOS to the “Off” status when
AC power is lost.