945G-M7 & 945P-M7 BIOS SETUP
25
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial ports.
The Choices:
Disabled,
3F8/IRQ4
(default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.
Onboard IR Function
The Choices: Disabled
(default), Enabled.
UART Mode Select
This item allows you to determine which Infra Red (IR) function of onboard I/O chip.
The Choices: IrDA
(default), AS KIR,
Normal.
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port. Full-duplex mode
permits simultaneous two-direction transmission. Half-duplex mode permits
transmission in one direction only at a time.
The Choices: Half
(default), Full.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which
I/O Address.
The Choices: 378/IRQ7
(default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
The Choices:
SPP
(default)
Using Parallel port as Standard Printer Port.
EPP
Using Parallel Port as Enhanced Parallel Port.
ECP
Using Parallel port as Extended Capabilities Port.
ECP+EPP
Using Parallel port as ECP & EPP mode.
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices:
3
(default), 1.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power
fail or interrupts occurs.
Off
Leaves the computer in the power off state.
On Reboots
the
computer.
Former-Sts Restores the system to the status before power failure or
interrupt occurs.
The Choices: Off
(default), On, Former-Sts.
