2
PV-WM Installation Guide v1.2|10.2018|en
Safety Instructions
Safety instructions must be followed in addition to International Standards (ISO/IEC)
*
, and other
safety regulations.
Caution
Caution indicates a hazard with a low level of risk which, if not avoided, could
result in minor or moderate injury.
Note
Note indicates an
important
remark, which should be taken into attention.
Caution
General requirements:
Read, follow and retain instructions – All safety and operating instructions
must be read and followed properly before putting the unit into operation.
Do not turn on the power supply until all installation procedures are
finished – this may lead to injury or equipment damage.
Do not disconnect or connect cables while unit is powered on – this may
lead to unit malfunction and software errors.
Do not expose unit to heat or fire – high temperature impact may lead to
case deformation and circuit board damage.
Make sure that all cables and screws are fastened properly - otherwise
case damage or circuit shortcut may happen.
Note
Additional requirements:
Use a clean, dry cloth to remove any dirt or dust from the unit.
*IEC 60204-1: Safety of machinery – Electrical equipment of machines. (Part 1: General requirements)
