4. After setting the timer, the display will return to show the
current room temperature. The Timer light will illuminate
to show that the timer is activated.
5. After the predetermined length of time has passed, the
humidifier will automatically shut off.
Setting the On Timer:
1. While the humidifier is off, press and hold the up and
down buttons simultaneously for 2 seconds.
2. By pressing the up and down buttons, program the
humidifier to turn on up to 16 hours in advance in
increments of 1 hour.
3. The humidifier will continue to run on Auto Mode (HI) at
45% until the user shuts it off.
REMOTE INSTRUCTIONS
1. Insert 2 AAA batteries into back of remote control.
2. Press the Mode button on remote to begin operation.
3. Use the remote to control the same features as the base
unit.
NOTE
: The timer function can only be activated on the
base unit. It cannot be activated via the remote control.
NOTE
: The remote will not shut off the humidifier by
holding the remote button for 2 seconds. The user needs
to scroll to “OF” to shut off the humidifier with the remote
control.
NOTE
: Do not mix new and old batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable (nickel-
cadmium) batteries.
Replacing the Wick
Through normal use, waterborne minerals and sediment
become trapped in the wick filter. The harder your water,
the greater amount of minerals in the water, and the more
often you will need to change your wick filter. Using the
Filter Monitor located on the top grill, you will be able to
check the life of the wick filter in your humidifier. When the
unit is turned off the Filter Monitor needle will read
“change”. After the needle reads change for 60 minutes,
the filter replacement is recommended. Regular filter
replacement is necessary to ensure optimal humidifier
performance.
6
made, the display will return to show the current room
humidity.
5. To stop the unit, press and hold the button for two
seconds, or keep pressing the button until the display
reads OF.
HUMIDISTAT INSTRUCTIONS
To take advantage of the Digital Humidistat, press the
MODE button until the speed is set in either the Auto HIGH
(A3), Auto MEDIUM (A2) or Auto LOW (A1) setting. Then
adjust the set humidity by using the up and down buttons.
Humidity will increase in increments
of 5%. When the humidity level is set,
the display will return to show the
current room humidity. When the
room humidity level rises above the
set humidity, the humidifier will stop.
When the humidity level drops below
the set humidity, the humidifier will
turn on automatically.
NOTE
: Allow up to 30 minutes for
the filter to fully absorb water and for
the unit to produce moisture.
NOTE
: The Digital Humidistat Humidifier has memory. This
means that when you turn the unit back on, it will be at the
last setting the humidifier was set at.
If you do not plan to use the humidifier for two or more
days, make sure any residual water is drained from the
water reservoir, base and wick filters to prevent algae or
bacteria growth.
USING THE PROGRAMMABLE TIMER
The Digital Humidistat allows the user to program the
humidifier to come on at a preset time, or turn off after a
set amount of time.
Setting the Off Timer:
1. Select the Mode and or humidity you wish the humidifier
to run in.
2. While the humidifier is running, press and hold the up
and down buttons simultaneously for 2 seconds. The
display will flash “00”.
3. By pressing the up and down buttons, program the
humidifier to turn off up to 16 hours later in increments
of 1 hour.
5
C
B
A
C. UP/DOWN Buttons
D. Timer Light LED Display
A. Control Panel
B. Mode/Off Button
D
Fig 2
BCM5520RC Visual_Eng.qxd 8/21/03 9:20 PM Page 7
