Waking up with the Alarm Beeper or Radio
The audible alarm begins with a quiet beep, and gradually intensifies to full volume over a period of
time. The alarm beeper is preset ON. To disable the audible beeper, press the PROGRAM button 5
times until the display reads
“WAKE BEEP”
or
“WAKE RADIO”
or
“AUDIO OFF”.
Then press
the (+) or (-) button to alternate among the three choices. When the beeper is on, the Beep Symbol ))
)
will be displayed. The Music Note symbol will be displayed when Wake Radio is selected. If you
choose to wake to the radio, the SunRise Controller will wake you up with a slow ramp up of the audio
volume to whatever station is programmed to Preset 1.
Waking up to a Flashing Light
If you would like to wake up to a flashing light, press the PROGRAM button until you see
“FLASHING OFF”
or
“FLASHING ON”
on the display. Press the (+) or (-) buttons until it reads
“
FLASHING ON.
” In this mode, the light will flash on and off when it reaches your preset alarm
time. When enabled, a lightning symbol will be displayed on the main screen.
Falling Asleep to the SunSet Sequence
Manually turn the light on to the intensity from which you wish the sundown to start. Then press the
ALARM button (so the Sun Symbol is illuminated) to begin the sunset sequence.
NOTE
: If you wish to
activate the sunset without activating the SunRise for the following morning, then make sure the
ALARM is not activated (the Sun Symbol is not illuminated). Then press and hold the SNOOZE
button for 2 seconds to begin the sunset. This is known as “
Friday Night Mode
” (FNM) because it
works well for Friday nights when one does not want to wake up early on Saturday morning. To exit
Friday Night Mode, press any non-radio related button.
Setting the Speed of the SunSet Sequence
Press the PROGRAM button until the display reads
“SUNSET”
followed by a number. Press the (+)
or (-) button, and the display alternates between:
“SUNSET 15”
(15 minute sunset),
“SUNSET 30”
(30 minutes - the Default),
“SUNSET 45
” (45 minutes), and
“SUNSET 60”
(60 minutes).
Falling Asleep with the Radio or Sleep Sounds
Press the PROGRAM button until the display reads “
AUDIO FADE AUTO.
” This setting will turn the
audio (radio or sounds) off after the lamp has extinguished. Press the (+) or (-) button to reach your
choice. “
AUDIO ON PERM
” will leave the audio on all night, “
AUDIO FADE 15
” will keep the
audio on for 15 minutes after Lamp Fade down is complete, “
AUDIO FADE 30
” for 30 minutes, etc.
Setting the Night Light
This feature allows you to have the light dim in the SunSet mode, but stops the dimming when it
reaches approximately 5% intensity, for use as a night light. Press the PROGRAM button until the
Display reads
“NIGHT LIGHT OFF,” “NIGHT LIGHT LOW,”
or
“NIGHT LIGHT HIGH.”
Then press the (+) or (-) buttons and the display will alternate between the three options.
Adjusting the Brightness of the Display
Press the PROGRAM button until the display reads
“DISPLAY HIGH,”
which is the default setting.
Press the (+) or (-) button, and the display changes to
“DISPLAY LOW”
or
“DISPLAY AUTO.”
In
the “
DISPLAY AUTO
” mode, the brightness of the display is automatically at a high level during the
day, but will switch to a lower level when you enable the alarm at nighttime so it does not disturb you
while sleeping.
6
