Radiant Heat Panel – Spectra 18, 24 and 32
E&OE
© 2018 Bio
3
General Electrical Safety
•
Inspect electrical equipment, extension
cords, power bars, and electrical fittings
for damage or wear before each use.
Repair or replace damaged equipment
immediately.
•
Ensure all power sources conform to
equipment voltage requirements and
are disconnected before connecting or
disconnecting equipment.
•
When wiring electrically powered
equipment, follow all electrical and
safety codes.
•
Wherever possible, use a residual
current device (RCD).
•
High voltage / high current power lines
may be present. Use extreme caution
to avoid contact or interference with
power lines. Electrical shock can be
fatal.
General Electrical Safety
•
Electrically grounded equipment must
have an approved cord and plug and
be connected to a grounded electrical
outlet.
•
Do NOT bypass the ON/OFF switch
and operate equipment by connecting
and disconnecting the electrical cord.
•
Do NOT use equipment that has
exposed wiring, damaged switches,
covers or guards.
•
Do NOT use electrical equipment in wet
conditions or in damp locations.
•
Do NOT use electrical cords to lift,
move or carry equipment.
•
Do NOT coil or knot electrical cords,
and ensure electrical cords are not trip
hazards.
General Service Information
•
The equipment must be serviced or
repaired at authorised service centres
by qualified personnel only.
•
Replacement parts must be original
equipment manufacturer (OEM) to
ensure equipment safety is maintained.
•
Do NOT attempt any maintenance or
repair work not described in this
manual.
•
After use, the equipment and
components may still be hot – allow the
equipment to cool and disconnect spark
plugs and/or electrical power sources
and/or batteries from it before making
adjustments, changing accessories or
performing repair or maintenance.
•
Do NOT make adjustments while the
equipment is running.
•
Perform service related activities in
suitable conditions, such as a
workshop.
•
Replace worn, damaged or missing
warning/safety labels immediately.
Beware of Children and Pets
•
Children should not be allowed to touch
or operate heaters or touch extension
cords, if used. All heaters should be
kept out of reach of children, preferably
stored or locked in a secure cabinet or
room when not in use.
Do Not Abuse the Power Cord
•
Never yank or pull on the power cord to
disconnect it from the mains supply
socket. Never carry your heater by its’
power cord. Keep the power cord away
from heat, oil, solvents and sharp
edges. Check the power cord regularly
for any damage and if the power cord
becomes damaged have it replaced by
an authorised service facility.
Extension Cords and Reels
•
This heater is NOT designed to run off
an extension cord. If you require an
additional power point, please have one
installed by a qualified electrician.
•
The use of extension cords may cause
power voltage loss which will result in
damage to the appliance this will NOT
be covered under warranty.
Installation
•
Always ensure you select the correct
fixing accessories which suit the
wall/ceiling material you are attaching
to, if in doubt please discuss with your
local retailer or local hardware store.
This heater is not designed for use
within 1m or above a water source. All
installations must meet the
requirements of Australia Standard
AS/NZS 3000:2007.
•
Ensure that the heater is not positioned
directly above, below or in front of a
power point or switch.
•
This heater is not designed to be used
with 3rd party timer or programmable
system.
FOR YOUR SAFETY
•
WARNING: Fire risk exists if this heater
is covered by or positioned close to
curtains or other combustible materials.
•
NOTE: If using this heater outside
ensure that it is connected directly to an
outdoor power point.
•
The electrical system of this heater
must be connected with an automatic
30mA circuit breaker and/or residual
current device (RCD).
•
If uncertain, have a qualified electrician
check your electrical system before
installation and/or use.
•
All electrical connections are made in a
dry area.
•
Outdoor power points must be
weatherproof and installed by a
qualified electrician.
•
We are not responsible for incorrectly
chosen fixing accessories or any
damage which may be caused by an
incorrectly fitted wall heater.
•
If required 15AMP power points must
be installed by a qualified electrician.
