©2010 BioSmart Technologies
Page 14
Maintenance Instructions (1500PCP & -PB)
Figure 1
Figure 2
The only maintenance that is required for the heater is the periodic cleaning of
the heater’s electrostatic filter (located at the back of the unit). This cleaning
should be performed at least once a month, or as dust becomes visible on the
filter, to ensure efficient operation of the heater.
Cleaning the Electrostatic Filter
1. Power the heater off by pressing the POWER button, located on the left side
of the Control Panel.
(NOTE: The sound of the heater’s fans will continue until
the heat has been completely vented, thus protecting the unit and preventing
waste by cycling the remaining heat into the room.)
**DO NOT unplug the heater until the sound of the fan has stopped, doing so
may cause damage to the unit.
2. When the heater’s fans have stopped (the heater will become completely
silent), unplug the heater .
3. Release the electrostatic filter by pushing the filter up from below (Figure 1).
4. Remove the electrostatic filter by pulling the filter down and out (Figure 2).
5. Clean the filter by vacuuming the filter until clear.
6. Replace the filter by sliding the top upwards into the spring-loaded slot on
the back of the heater, then gently press the bottom of the filter into place.
