10
Troubleshooting
When the jug
is on the base
and the control
panel does not
light up.
1. Not plugged into electricity. Replug cord into
power outlet.
2. Electricity not turned on. Check switch is turned to
ON position.
Ingredients
are difficult to
blend
Too many solid ingredients. Add more liquid
Motor stops
suddenly
during
operation.
1. Too much food may cause motor to cut out. Turn
off. Remove some of the food and try again.
2. Long durations of operating or adding too much
hard food may trigger the protection mechanism.
Rest the blender for 20–45 minutes then restart.
3. Voltage shortage. The power voltage is
unmatched or insufficient for the blender. Make
sure the power supply is correct.
4. Adding too much food takes the working current
beyond the preset maximum. Rest the blender
for 20 – 45 minutes and restart it.
Cleaning
After finishing your blending session, you can clean the jug in various ways
depending on the ingredients you have used.
• For thick or oily ingredients, add warm water to the jug with a few drops of
detergent and blend for 30 seconds. Remove the jug and rinse with clean
water. Wipe the main unit with a wet or dry cloth.
• Rinse the jug and lid directly under the tap and use a clean cloth to wipe up
the residual water.
• Always place jug in upright position when leaving to dry. Try not to have
liquid contacting the underside of the drive shaft.
EN
