Binzel ABIPLAS WELD, Руководство по эксплуатации

Страница: 33 / 84

EN - 13
ABIPLAS
®
WELD 6 Putting into operation
Charge the entire cooling system as follows when used for the first time and
after every cable assembly change:
1 Disconnect the coolant return hose (1) from the re-circulating
cooling unit (3) and hold it over a collecting device.
2 Close the opening at the coolant return hose (1) and open it again by
repeatedly and abruptly releasing it, until the coolant is flowing
continuously and without air bubbles into the collecting device.
3 Switch off the re-circulating cooling unit (3) and reconnect the coolant
return hose (1) .
1 Coolant return hose
2 Coolant flow hose
3 Re-circulating cooling unit
4 Control lead
Fig. 5 Connecting the coolant
1 2 3
4
NOTE
Before putting the plasma welding torch into operation, check the coolant
level in the re-circulating cooling unit.