Field
Description
Enter the subscriber number to be set as calling party number.
Monitored Interfaces
Only if ISDN Theft Protection Servic is enabled.
Use Add to add a new interface to the list.
Select from the available interfaces those to which the ISDN
theft protection function is to be applied.
Fields in the Options Advanced Settings menu
Field
Description
Number of Dial Retries
Enter the number of dial attempts that the gateway is to make to
call itself by ISDN after a reboot.
Possible values are
1
to
255
.
The default value is
3
.
Timeout
Enter the time in seconds that the gateway is to wait before try-
ing again after an unsuccessful attempt to call itself.
Possible values are
2
to
20
.
The default value is
5
.
14.9 Funkwerk Discovery
14.9.1 Device Discovery
The funkwerk Discovery protocol is used to identify and configure bintec access points that
are in the same wired network as your device. Once an access point has been discovered,
certain basic parameters (node name, IP address, netmask, and device address) can be
configured on the access point (provided you know the administrator password).
Note
Any bintec access points that exist are determined by means of a multicast. The IP
address of the access point is therefore irrelevant.
Please note that the discovered bintec access points are not stored in the flash, which
Funkwerk Enterprise Communications GmbH
14 Local Services
bintec R200 Series
343
