Binks AA4400A, Руководство по эксплуатации

Страница: 9 / 17

© 2013 Finishing Brands UK Ltd.
9
7 - Dimensions & connections
(all dimensions in mm)
Stage 2
‘Captive’
Rotate clockwise
to stop
Gap
Stage 1
‘Locked’
Rotate anti-clockwise
Until clamped
A
– Fluid inlet 1/4” NPS (x2) (see fluid
connections & options
275 Bar / 4000 psi Maximum
B
– Trigger/Cylinder M5
4 to 10 Bar / 60 to 145 psi
C
– Pattern & Length air supply 1/4” BSP
D
– Location hole Ø5 x 4 deep
E
– Mounting hole M8 x 7.5 deep
F
– Mounting hole M5 x 9 deep (x2)
G
– Mounting hole M8 x 10 deep (x2)
Y
– Pattern control valve (if fitted)
Z
– Length control valve (if fitted)
Important: The spray gun must be earthed to dissipate any electrostatic
charges which may be created by fluid or air flows. This can be achieved
through the spray gun mounting, or conductive air/fluid hoses. Electrical
bond from the spray gun to earth should be checked with an Ohm meter.
A resistance of less than 10
6
Ohms is recommended