Binder KBF 115 (E5.2), Руководство по эксплуатации

Страница: 44 / 103

KBF / KBF P (E5.2) 02/2012 page 44/103
8.2 Entering the set point values for KBF P when operating without illumination
• Adapt the setting of the temperature set-point according to the following table
Target temperature value Set-point entry without illumination
KBF P 240 KBF P 720
10 °C 10 °C 11 °C
20 °C 19 °C 21 °C
30 °C 32 °C 32 °C
40 °C 42 °C 42 °C
50 °C 51 °C 53 °C
60 °C 63 °C 63 °C
70 °C 72 °C 74 °C
• Adapt the setting of the humidity set-point according to the following table
Target humidity value Set-point entry without illumination
KBF P 240 KBF P 720
10 % r.H. 10 % r.H. 9 % r.H.
20 % r.H. 19 % r.H. 17 % r.H.
30 % r.H. 26 % r.H. 25 % r.H.
40 % r.H. 36 % r.H. 34 % r.H.
50 % r.H. 45 % r.H. 43 % r.H.
60 % r.H. 55 % r.H. 52 % r.H.
70 % r.H. 65 % r.H. 61 % r.H.
80 % r.H. 75 % r.H. 71 % r.H.
8.3 Performance after power failure in Manual Mode
In Manual Mode (HAND), all functions return exactly to the same status the chamber had before power
failure. The set-points are immediately resumed. No error message indicating that a power failure has
taken place is displayed. However, the power failure will appear in the event list.
9. Program operation
The 2-channel program controller MB1 permits programming temperature and humidity cycles. It offers 25
program memory positions with 100 program sections each. The total cumulative number of program
sections is limited to 500. It is not possible to link several programs.
For each program section a temperature set-point, a humidity set-point, the fan speed (0% to 100%), and
the switching-state of up to 8 operation lines (non-functional with standard unit) can be entered.
Programming is possible directly by the keypad of the controller or graphically by the software APT-
COM™ 3 DataControlSystem (option, chap. 15.1) specially developed by BINDER.