Read these notes before installation
Connection and
conditions for use
You can connect your Pegasys 8 Triple to a public exchange
line in the UK; or to an extension on an approved PBX using
DTMF (tone) signalling and timed-break recall (TBR).
The
ringer equivalence numbers (RENs)
of all instruments
(phones, fax machines, etc.) connected to an exchange line
must not add up to more than 4
— otherwise, one or more
of them may not ring and/or answer calls correctly. The
Pegasys 8 Triple has a REN of 1, and most other telephones
have a REN of 1 unless marked otherwise.
Sites for the base
unit and charger
pod
The
base unit
should be installed where:
n
the mains adapter plug will reach a 230-V
AC
switched
mains supply socket —
never try to lengthen the mains
power cable
n
the telephone cable will reach your telephone line socket or
extension socket
n
it is not close to another telephone — this can cause radio
interference
n
it is not close to a sink, bath or shower, or anywhere else
where it might get wet
n
it is not close to other electrical equipment — fridges,
washing machines, microwave ovens, TVs, fluorescent
lights, etc.
To use your handsets and base unit together, you must be
able to establish a radio link between them. Be aware that:
n
Siting the base unit as high as possible will
give better results — in a two-storey house,
the best position may be on the first-floor
landing.
n
Any large metal object — like a refrigerator,
or a filing cabinet — between the handset
and base unit may block the radio signal.
n
Other solid structures, like walls, may reduce
the signal strength.
The
charger pods
should be installed where
the mains adapter plug will reach a 230-V
AC
switched mains supply socket —
never try to
lengthen the mains power cable
. Do not
place a charger pod where it might get wet.
INSTALLATION AND SET-UP
4
R
I O
A D
W AV
E S
Connecting the base unit and chargers
INSTALLATION AND SET-UP
Binatone Help Line: 0208 344 8870, 9.00 am to 5.00 pm, Monday to Friday
5
Choose a suitable site for the base unit.
Make sure it is not near to another
telephone, nor to other electrical
equipment
Plug the mains power lead and the
telephone line cord into the back of
the base unit
Plug the mains adapter into a
230 V AC, 50 Hz mains socket,
with the switch on the socket
set to OFF
Switch on mains power at the socket
Connect a mains power lead into the
socket on back of each charger pod
Plug each mains adapter into a 230 V AC,
50 Hz mains socket and switch on mains
power
The charger pods do not have a connection
to the telephone line
1
2
3
4
5
The Pegasys 8 Triple base unit must be used with mains adapter,
part no. XX002098D, supplied with the unit. Using any other
adapter will result in non-compliance with EN41003, and will
invalidate any approval given to this apparatus.
The Pegasys 8 Triple charger pods must be used with mains
adapter, part no. XX002101D, supplied with the unit. Using any
other adapter will result in non-compliance with EN41003, and
will invalidate any approval given to this apparatus.
DC 9V
RINGER
HIGH LOW
NOTE: you can set
the base unit ringer
volume using the
switch located
between the two
cable connectors
Содержание Pegasys 8 Triple
Страница 11: ...20 ...
