7.4.2
Change the dial mode
1. Press <MENU> and <UP/DOWN> to select
BS SETTINGS
2. Press <OK> and <UP/DOWN> to select
DIAL MODE.
3. Press <OK> and <UP/DOWN> to select
TONE
or
PULSE
(The current setting is indicated by an asterisk to the right).
4. Press <OK> to confirm.
You should normally leave the dialling mode at its default setting of TONE (also
called DTMF) unless the phone is connected to an old exchange that only
Note:
If PULSE dialling is set, you can press the * key to switch to TONE
recognises
PULSE
dialling.
7.4.3
Change the Flash (Recall) Time
1. Press <MENU> and <UP/DOWN> to select
BS SETTINGS.
2. Press <OK> and <UP/DOWN> to select
FLASH TIME.
3. Press <OK> and <UP/DOWN> to select your desired flash time (
SHORT,
4. Press <OK> to confirm.
You may need to change the recall (flash) time if your phone is connected to a
PBX. The recall time options are SHORT (the default value of 100ms),
the right).
MEDIUM (300ms) or LONG (600ms).
MEDIUM,
LONG,
with the current setting indicated by
7.4.4
Change the System PIN Code
A 4-digit system PIN code is used for changing the system settings of the base
station. It is used to protect your phone against unauthorised use. The default
system PIN code is 0000.
1. Press <MENU> and <UP/DOWN> to select
BS SETTINGS
.
2. Press <OK> and <UP/DOWN> to select
CHANGE PIN
.
3. Press <OK> and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press <OK> and enter the new system PIN.
6. Press <OK> and enter the new system PIN again.
Note:
If the new PIN entered in Step 6 is not the same as the new system PIN
entered in Step 5, you must enter the new system PIN at step 5 again.
7. Press <OK> to confirm
an asterisk to
dialling for the rest of that call.
23
