Binatone FBM-311, Инструкция по эксплуатации

Страница: 6 / 28

6
USER INSTRUCTION
Use of the appliance
1. Install the appliance on a flat horizontal sur-
face in front of a comfortable seat (chair).
2. Fill the massage appliance with water of re-
quired temperature to the maximum level.
To enhance the effect of the massage, you
may add salt (preliminary dissolved in a small amount of water)
or bath oil to water.
3. Connect the appliance to electric mains.
4. Sit down and put down feet in bath.
Always put in and take
out feet from the bath in whilst in sitting position.
5. Set the switch of operation mode (3) in required position.
6. For more intense foot massage, install massage rollers (7) on the
surface for acupunctural massage (5) , as shown in the figure.
7. After massage procedures, set the switch (3) in position «0» and
follow instructions in the section «Maintenance».
Description of operation modes
of the appliance
Heating
Massage appliance heats water to 40 o C, irrespective of its
starting temperature. Hence, you can fill it with cold water. In this
case, that heating the water will take time.
Infrared radiation
Infrared radiation improves circulation in legs and relieves mus-
cular stress. Infrared radiation leads to fast cell renewal. It has an
anti-inflammatory and analgesic effect.
Vibration massage with infrared radiation
Vibration massage relives muscular stress and improves circu-
lation. Vibration massage can be used both with and without filling
the appliance with water. Combination of infrared radiation and
massage gives a very good therapeutic effect.
Note : time of vibration massage without water should not
exceed 10 minutes, with water – 20 minutes.
Hydromassage with heating
The combined effect of warm water and hydromassage gives
the sensation of being touched and you will feel a calming effect
BEFORE USE
Remove all package materials from the appli-
ance.