10
6.2.1. Point-to-Point IR Control — Stereo (3.5mm) IR Receiver
When using a powered IR receiver, the DIP switch for IR RCVR PWR should be set to ON. In
this case a 3.5mm (1/8
"
) stereo jack has to be used to send 9V DC power to the receiver.
CAUTION: DO NOT
connect a mono cable to this connection as damage may occur.
1
2 3
ON
1
ON
2
3
9V DC (Sleeve)
GND (Ring)
IR Signal (Tip)
FIGURE 6: Point-to-Point IR settings
6.2.2. Control System - Mono (3.5mm) IR Receiver
When using a control system which generates the signal through a mono jack, the IR RCVR
PWR switch should be in the OFF position.
1
2 3
ON
1
ON
2
3
GND (Sleeve)
IR Signal (Tip)
FIGURE 7 : Control System IR settings
Transmitter
Receiver
Pinout Configuration
IR Signal (Tip)
GND (Sleeve)
9V DC(Sleeve)
Transmitter
Receiver
Pinout Configuration
IR Signal (Tip)
GND (Sleeve)
