Binary B-500-EXT-330-RS-IP, Руководство пользователя, Страница: 6 / 16

pg.6
B-500-EXT-330-RS-IP Installation and Users Manual
4. CONNECTIONS AND CONTROLS
4.1. B-500-EXT-330-RS-IP Transmitter
HDBaseT
1 2
ON
DTE ON
DCE SERVICE RS-232
5 3 2
LINK
ETHERNET
+24V DC 1A
INPUT
PWR
HDMI IN
3 2 4
HDBaseT
1 2
ON
RS-232
5 3 2
LINK DTE
DCE ON
SERVICE
7 8 9 1 5 6 10
1. IR Control In (3.5mm {1/8”} Mono)
Connect the IR output of an Automation
System or IR connecting block to send IR
signals to the remote location. To simplify
connection to most Automation Systems,
this port does not supply power.
2. IR Flasher Out (3.5mm {1/8”} Mono)
Connect an IR flasher to use IR signals sent
from the remote location.
3. HDMI In (HDMI)
Connect an HDMI cable to the HDMI output
of a source, AV Receiver, HDMI Splitter, or
HDMI Switcher/Matrix.
4. Ethernet (RJ45)
Connect to an IP device to send Ethernet
signals to the Receiver.
5. Power LED
Indicates current state of Power, illuminates
RED when power is applied.
6. Latch-Locking Power Jack
Connect to the included 24V DC 1A Power
Supply.
7. RS232 Operation Mode Dip Switches
Switch 1: Configures RS232 DB9 connection
pins for DCE or DTE communication.
Switch 2: Configures RS232 DB9 connection:
ON for Pass-Through (normal operation) or
SERVICE for Firmware update.
See section 5.3.1.1 RS232 Operation Mode.
8. RS232 Control (DB9)
Connect to an Automation System RS232
control port to send RS232 signal to the
Receiver.
See section 5.3.1 RS232 Control (DB9)
Connection.
9. HDBaseT Link to Receiver (RJ45)
Connect to HDBaseT RJ45 on Receiver; this
connection follows standard TIA/EIA-568B.
10. Signal Link LED
Indicates link status with Receiver; illuminates
GREEN when sync is present. Blinks when in
Low Power Mode.