BIMG Metvisa TFE 6 Series, Инструкция по эксплуатации

Страница: 15 / 24

15
Never use abrasive products or sponges and substances containing acids or chlorine to
clean the metallic parts, as they may scratch or damage the surface of the parts causing corrosion
points. Do not spill water on the engine and electrical parts for cleaning, otherwise, turning it on
may cause electric shock or even burn the device.
IMPORTANT
The manufacturer shall not be liable for any direct or indirect damages caused by non-
compliance with these standards and other instructions presented in this manual.
ATTENTION!
It is extremely important that the products used in cleaning ensure maximum cleanliness
and are not toxic.
5.2 Maintenance and Behavior in Case of Breakdowns
The operator must be instructed to perform routine inspections, making minor
adjustments, the cleaning and to observe signs of breakdowns that could occur. Examples include:
checking for extraneous noise; loss of power of the appliance; the non-performance by the
appliance of the service to which it proposes; among others. Actions such as these are essential to
ensure a longer equipment life.
ATTENTION!
When maintenance is done (even if small adjustments), always unplug the appliance from
the power grid.
It is also recommended to always perform preventive maintenance, checking and
adjusting gaps, cleaning the internal parts, etc. When detecting broken or malfunctioning parts,
always replace using original parts.
By carrying out preventive maintenance, the inconvenience of keeping the device still
when needed most is eliminated, the cost of maintenance is reduced and the risk of accidents is
reduced.
ATTENTION!
Preventive maintenance requires a trained professional.
Make sure the device is disconnected from the power grid.
Whenever an item related to the safety of the device is removed (e.g. when performing
maintenance), put it back in its proper place and confirm that it is performing its function
correctly.