BIMG Metvisa FTG.150B, Инструкция по эксплуатации

Страница: 13 / 44

13
3.2 Hydraulic Installation
To activate the steam function of the oven, it is necessary to install the equipment near a fixed
point of cold water.
The equipment is supplied with a solenoid water valve for hose coupling or for fitting a 3/8
"water supply hose (hose and pipes not supplied with the equipment) located on the back of the
control panel housing.
The hose that will be used to connect to the water supply must comply with IEC 61770.
When installing the hose, ensure that the pressure reducing ring (attached to the equipment) is
properly sealed to prevent leakage. Tighten the connection manually. Do not use tools.
The water supply pressure must be at least 20 kPa (3 mA) and at most 78 kPa (8 mA).
CAUTION!
It is recommended that the water be connected directly from the water box so as not to
generate a high pressure or that it has variation, as in the public network. Very high water
boxes should also be avoided.
It is also recommended to install a filter to eliminate water impurities, avoiding the calcification
and internal corrosion of the equipment.
Install a water log on the grid to allow water to be closed when necessary.
CAUTION!
In case of use of removable hoses to feed the equipment, it is recommended that new hoses
should always be used and comply with IEC 61770. In case of hose changes, dispose of old
hoses and always replace with new hoses.
The power supply hose does not come with the machine.
In case the excess steam turns into water inside the oven (chamber), it may be drained
through the water outlet pipe located between the bottom of the chamber and the oven burners. It is